A little water leak might cause a lot of damage to your property, and it often stays undetected till it’s far too late, at which point it’s too late, and you’ll have to pay for costly fixings. Ceilings, carpets, and walls can be expensive to restore. You’d be shocked to realize that even minor repairs can cost thousands of dollars.
Things to Check to Prevent Water Damage
As a property owner, you should always know how to keep your home safe from water damage. We’ll show you how to prevent water damage in a few easy steps:
1. Check your toilets.
Look for any water that shouldn’t exist on the flooring. Remove the cistern’s top and ensure that the float is adjusted to the right level (usually indicated by the letters WL on the inside). So it is not overrunning into the overflow pipe. Usually, all it takes is a small adjustment. Leak detection and repair can save you a lot of money and time. Click here to find out more about water damage services.
2. Check your plumbing system.
Check your plumbing, particularly your water pipes, both inside and outside your home. Check the area around your sinks, basins, and cabinets. Check under your sink for puddles or leaks from your pipes; also, plug your sinks and fill them up; after that, remove the plug and look for leaks below. If there is any water under, look for the source of the leak; it could be a simple dripping faucet or a leaking waste that is easily fixed. You can visit water cleanup Naples in case you discover water leaks.
3. Check your hot water cylinder.
Look for leaks, wet patches on the floor, or even small jets of water as you inspect the valve work. Also, make sure the water isn’t pouring out of the vent on low-pressure open vented hot water cylinders.
4. Water valves.
Above all, make sure you and your family know where to turn off the water in an emergency. Knowing where your water shutoff valve is located can save you thousands of dollars over time. There will usually be a shutoff valve in the front of your property (usually on the Council verge) with a blue lid to identify it if you have reticulated water (town supply). Additionally, a water pump and the water tank shutoff valve must be turned off on the house with a non-reticulated water supply (your water comes from storage tanks).
5. Check your roofing.
Check your roof and spout outside of your home for any problems. Constantly clean out all fallen leaves from your spouting, as blocked spouting, particularly inner gutters, can cause major water damage to your ceilings. Additionally, check roof penetrations such as chimneys and flues, particularly flashings.
Loose nails or screws, broken flashings, or even gaps under flashings are all signs of roof problems. Look for wet patches on your ceiling also. Roof leaks, even little ones, can quickly cause serious ceiling and structural damage. Tek screws can replace loose nails, and Plumbers Roofing Silicone can be used to reseal flashings.
Conclusion
You have to remember that it is better to be safe than sorry. If you discover any sign of a water leak anywhere, no matter how small it seems, have it repaired immediately or repair it yourself. You might put it off and forget about it, and then the small leak turns into a huge flood when you’re off shopping or vacationing.
